I'm wondering if it would be possible to rebuild the A frame ramp that goes over the tree branch to make it wider?
After much hesitation to try it I finally did and had a few successful rides over it.
The last time I tried it, the bike started to roll off the ramp which bumped the front sprocket or chain ring.
My front sprocket got bent to where it had to be replaced.
(I am not 100% sure if the ramp was the cause since I did not notice it bent until after riding it around for a bit longer. It could have been something else but I don't remember anything different hitting the sprockets.)
If this is possible or any interest I would be willing to donate time and/or materials and/or to CORP to create a wider and less intimidating ramp for riders of all skill levels.